Supero SUPERSERVER 8027R-7RFT+, Руководство пользователя

Страница: 53 / 131

5-2
SUPERSERVER 8027R-TRF+/7RFT+ USER'S MANUAL
5-2 Connecting Cables
Now that the serverboard is installed, the next step is to connect the cables to the
board. These include the data (ribbon) cables for the peripherals and control panel
and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have been
carefully routed to prevent them from blocking the fl ow of cooling air that moves
through the system from front to back. If you need to disconnect any of these cables,
you should take care to keep them routed as they were originally after reconnecting
them (make sure the red wires connect to the pin 1 locations). The following data
cables (with their locations noted) should be connected. (See the layout on page
5-9 for connector locations.)
•
SATA drive data cables (I-SATA0 ~ 2)
•
Control Panel cable (JF1)
Important! Make sure the the cables do not come into contact with the fans.
Connecting Power Cables
The X9QRi-F+/X9QR7-TF+ serverboard has a 24-pin primary power supply
connector (JPW1) for connection to the ATX power supply. In addition, there are
four 8-pin secondary power connectors (JPW2-5), which must be connected to
your power supply.
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure 5-1
for the pin locations of the various front control panel buttons and LED indicators.
All JF1 wires have been bundled into a single ribbon cable to simplify this
connection. Make sure the red wire plugs into pin 1 as marked on the board. The
other end connects to the Control Panel PCB board, located just behind the system
status LEDs on the chassis. See Chapter 5 for details and pin descriptions.