Supero SuperServer 6027PR-HC1FR, Руководство пользователя

Страница: 91 / 138

Chapter 6: Advanced Chassis Setup
6-15
6-11 Drive Bay Installation/Removal
Accessing the Drive Bays
SAS/SATA Drives: You do not need to access the inside of the chassis or remove
power to replace or swap drives. Proceed to the next step for instructions. You must
use standard 1" high, SAS/SATA drives in the system.
Note:
Refer to Supermicro's web site for setup guidelines: <http://www.supermicro.
com/support/manuals/>.
The chassis contains four individual serverboards in separate node
drawers (Figure 6-13). Each serverboard node controls a set of three hard drives.
Note that if a serverboard node drawer is pulled out of the chassis, the hard drives
associated with that node will power down as well.
Serverboard Drawer Locations in the Chassis
Serverboard B
Controls HDDs B1, B2 and B3 Serverboard D
Controls HDDs D1, D2 and D3
Serverboard A
Controls HDDs A1, A2 and A3 Serverboard C
Controls HDDs C1, C2 and C3
Figure 6-13. Hard Drives and the Corresponding Serverboards
SB:
A
SB:
B
SB:
C
SB:
D
1
A
1
B
1
C
1
D