Supero SuperServer 5028R-WR, Руководство пользователя

Страница: 64 / 130

5-18
S
UPER
S
ERVER 5028R-WR User's Manual
T-SGPIO Header
Three SGPIO (Serial General Pur-
pose Input/Output) headers are used
to communicate with the enclosure
management chip on the backplane.
See the table on the right for pin
definitions.
T-SGPIO Header
Pin Definitions
Pin# Definition Pin Definition
1 No Connection 2 No Connection
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 No Connection
Power LED/Speaker
On the JD1 header, pins 1-3 are for
a power LED and pins 4-7 are for the
speaker. Close pins 4-7 with a jumper
to use an external speaker. If you wish
to use the onboard speaker, please
close pins 6-7. See the table on the
right for speaker pin definitions.
Speaker Connector
Pin Settings
Pin Setting Definition
Pins 4-7 External Speaker
Pins 6-7 Internal Speaker
PWR LED Connector
Pin Definitions
Pin# Definition
1 Anode (+)
2 Cathode (-)
3 NA
Overheat/Fan Fail LED
The JOH1 header is used to connect
an LED indicator to provide warnings
of chassis overheating and fan failure.
This LED will blink when a fan failure
occurs. Refer to the table on the right
for pin definitions.
OH/Fan Fail LED
Status
State Message
Solid Overheat
Blinking Fan Fail
Overheat LED
Pin Definitions
Pin# Definition
1 VDC
2 OH Active
Serial Port Pin Definitions
(COM1/COM2)
Pin # Definition Pin # Definition
1 DCD 6 DSR
2 RXD 7 RTS
3 TXD 8 CTS
4 DTR 9 RI
5 Ground 10 No Connection
Serial Ports
One serial port (COM1) is located
next to USB 0/1 VGA port. COM2 is
located behind COM1 on the mother-
board. See the table on the right for
pin definitions.