Supero SUPERSERVER 1026T-UF, Руководство пользователя

Страница: 59 / 118

Chapter 5: Advanced Serverboard Setup
5-9
Figure 5-3. Installing DIMM into Slot
Possible System Memory Allocation & Availability
System Device Size Physical Memory Remaining
(4 GB Total System
Memory)
Firmware Hub fl ash memory (System BIOS) 1 MB 3.99
Local APIC 4 KB 3.99
Area Reserved for the chipset 2 MB 3.99
I/O APIC (4 Kbytes) 4 KB 3.99
PCI Enumeration Area 1 256 MB 3.76
PCI Express (256 MB) 256 MB 3.51
PCI Enumeration Area 2 (if needed) -Aligned on 256-MB boundary- 512 MB 3.01
VGA Memory 16 MB 2.85
TSEG 1 MB 2.84
Memory available to System BIOS & OS applications 2.84
DIMM Population Table
DIMM
Slots per
Channel DIMMs
Populated
per Channel DIMM Type (Reg.=
Registered) Speeds (in MHz) Ranks per DIMM
(any combination;
SR=Single Rank,
DR=Dual Rank,
QR=Quad Rank)
2 1 Reg. DDR3 ECC 800,1066,1333 SR or DR
2 1 Reg. DDR3 ECC 800,1066 QR
2 2 Reg. DDR3 ECC 800,1066 Mixing SR, DR
2 2 Reg. DDR3 ECC 800 Mixing SR, DR,QR
memory allocation to system devices, memory remaining available for operational
use will be reduced when 4 GB of RAM is used. The reduction in memory availability
is disproportional. (Refer to the Memory Availability Table below for details.)
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Top View of DDR3 Slot
Release Tab
Release Tab
Note: Notch should align
with the receptive key
point on the slot.
Notch
Notch
Front View