Supero SUPER S2DG2, Руководство пользователя и BIOS

Страница: 77 / 96

Chapter 5: Running Setup
5-19
On-Board Parallel Port
This option specifies the base I/O port address of the parallel port on the
motherboard. The settings are
Auto
(AMIBIOS automatically determines the
correct base I/O port address),
Disabled
,
378
,
278
or
3BC
.
Parallel Port Mode
This option specifies the parallel port mode. The settings are Normal , Bi-Dir ,
EPP or ECP . When set to Normal, the normal parallel port mode is used.
Use Bi-Dir to support bidirectional transfers. Use EPP (Enhanced Parallel
Port) to provide asymmetric bidirectional data transfer driven by the host
device. Use
ECP
(Extended Capabilities Port) to achieve data transfer rates
of up to 2.5 Mbps. ECP uses the DMA protocol and provides symmetric
bidirectional communication.
Note: The Optimal default setting for this
option is Bi-Dir and the Fail-Safe setting is Normal
.
EPP Version
The settings are 1 . 7 or 1 . 9 . Note: The Optimal and Fail-Safe default
settings are N/A.
Parallel Port IRQ
This option specifies the IRQ to be used by the parallel port. The settings
are 5 or 7 .
Parallel Port DMA Channel
This option is only available if the setting of the parallel port mode option is
ECP
. The settings are
0
,
1
,
2
,
3
,
5
,
6
or
7
.
Note: This option is N/A
.
On-Board IDE
This option specifies the onboard IDE controller channels to be used. The
settings are Disabled, Primary , Secondary or Both .
5-2 Auto Detect Hard Disks
Date and Time Configuration
The current values for each category are displayed. Enter new values through
the keyboard.
Floppy A
Floppy B
Choose the Floppy Drive A or B icon to specify the floppy drive type. The
setting for Floppy Drive A is
1.44 MB 3 1/2 inch
and for Floppy Drive B is
Not Installed
.