Supero SUPER S2DG2, Руководство пользователя и BIOS

Страница: 72 / 96

BIOS User's Manual
5-14
Suspend Timeout (Minutes)
This option specifies the length of a period of system inactivity while in
standby state. When this length of time expires, the computer enters
suspend power state. The settings are
Disabled
and
4 Min through 508 Min
in 4 minute intervals .
Slow Clock Ratio
The value of the slow clock ratio indicates the percentage of time the
STPCLK# signal is asserted while in the thermal throttle mode. The settings
are Disabled, 0-12 . 5% , 12.5- 25% , 25- 37 . 5% , 37 . 5-50% , 50 - 62 . 5% , 62 . 5-75% ,
or
75-87.5%
.
Display Activity
This option specifies if AMIBIOS is to monitor display activity for power
conservation purposes. When this option is set to Monitor and there is no
display activity for the length of time specified in the Standby Timeout
(Minute) option, the computer enters a power savings state. The settings are
Monitor or Ignore .
Device 6 (Serial port 1)
Device 7 (Serial port 2)
Device 8 (Parallel port)
Device 5 (Floppy disk)
Device 0 (Primary Master IDE)
Device 1 (Primary Slave IDE)
Device 2 (Secondary Master IDE)
Device 3 (Secondary Slave IDE)
When set to Monitor , these options enable event monitoring on the specified
hardware interrupt request line. If set to Monitor and the computer is in a
power saving state, AMIBIOS watches for activity on the specifies IRQ line.
The computer enters the Full On state if any activity occurs. AMIBIOS
reloads the Standby and Suspend timeout timers if activity occurs on the
specified IRQ line.
Note: The Optimal default setting for each option is
Ignore with the exception of Devices 0 (Primary Master IDE) and 6 (Serial
Port 1) which should be set to Monitor. The Fail-Safe default for each
option is Monitor.
LAN Wake-Up
RTC Wake-UP
Options for LAN Wake-Up and RTC Wake-Up are Disabled or Enabled .
When enabled, the Hour and Minute functions become available.