Supero A+ SERVER 4042G-6RF, Руководство пользователя

Страница: 24 / 116

2-8
A+ SERVER 4042G-6RF/TRF User's Manual
2-6 Checking the Serverboard Setup
After setting up the the system, you will need to open the unit to make sure the
serverboard is properly installed and all the connections have been made (see
Figure 2-5).
Accessing the Inside of the System
1. If rack mounted, first release the retention screws that secure the unit to the
rack.
2. Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
3. There are two screws that secure the cover to the chassis – remove these
first.
4. Using the indentations on the side cover (see Figure 2-5), push the cover to
slide it off the chassis.
5. Then lift the cover from the chassis to gain full access to the inside of the
server.
Checking the Components and Setup
•
You may have four processors already installed into the serverboard. Each
processor should have its own heatsink attached. See Chapter 5 for instructions
on processor installation.
•
Your server may have come with system memory already installed. Make sure
all DIMMs are fully seated in their slots. For details on adding system memory,
refer to Chapter 5.
•
If desired, you can install add-on cards to the system. See Chapter 5 for details
on installing PCI add-on cards.
•
Make sure all power and data cables are properly connected and not blocking
the chassis airflow. See Chapter 5 for details on cable connections.