Supermicro SuperServer 6014H-i, Руководство пользователя

Страница: 42 / 126

5-8
S
UPER
S
ERVER 6014H-i2/6014H-i/6014H-Xi Manual
Figure 5-5a. Side View of DIMM Installation into Slot
To Install: Insert module vertically and press down until it snaps into
place. Pay attention to the bottom notch.
To Remove: Use your thumbs to gently push each release tab outward
to free the DIMM from the slot.
Memory Support
All three serverboards use an interleaved memory scheme, so memory mod-
ules must be installed two at a time (two DIMMs in the same bank). You
should not mix modules of different sizes and/or speeds.
The X6DHR-iG2 has eight 240-pin DIMM slots that can support up to 16 GB
of registered ECC DDR2-400 SDRAM. The serverboard has has been de-
signed to support 2 GB DIMM modules for each memory slot, but it has only
been validated with 1 GB memory modules.
The X6DHR-iG/X6DHR-XiG has eight 184-pin DIMM slots that can support up
to 16 GB of low-profile, registered ECC DDR333 SDRAM or 32GB of low-
profile, registered ECC DDR266 SDRAM. The serverboard has has been
designed to support 2 GB DIMM modules for each memory slot, but it has only
been validated with 1 GB memory modules.
Note: if ECC registered DDR333 (PC2700) memory modules are used, con-
figurations of four double-banked DIMMs or six single-banked DIMMs are
supported.
Memory Speed Jumpers
Depending on what type of memory you use, you may need to change the
J4F4 and J4F5 (Memory Speed Select) jumpers. See section 5-9 for details.