Supermicro SuperServer 6014H-i, Руководство пользователя

Страница: 67 / 126

Chapter 6: Advanced Chassis Setup
6-9
6-5 Power Supply
The SuperServer 6014H-i2/6014H-i/6014H-Xi has a single 420 watt power
supply, which is auto-switching capable. This enables it to automatically
sense and operate at a 100v - 240v input voltage.
Power Supply Failure
If the power supply unit fails, the system will shut down and you will need
to replace the unit. Replacement units can be ordered directly from
Supermicro (see contact information in the Preface). As there is only one
power supply unit in the 6014H-i2/6014H-i/6014H-Xi, power must be com-
pletely removed from the server before removing and replacing the power
supply unit for whatever reason.
Removing/Replacing the Power Supply
1. Removing the power supply:
First shut-down the operating system. Then turn the power switch on
the control panel off and unplug the power cord from the server. You
may have to pull the server out from the rack to remove the top cover.
To remove the top chassis cover, press the two release buttons on the
cover (near the front) and then push the cover rearward about one inch
before lifting it off. Locate the power connectors leading from the power
supply to the motherboard and disconnect them. Next, push the release
tab on the back of the power supply to the right and pull the unit straight
out of the chassis with the handle provided.
2. Installing a new power supply:
Replace the failed unit with another unit of the same input voltage, output
voltage and wattage. It is highly recommended to replace it with exactly
the same model power supply (p/n: PWS-0053-20). Carefully insert the
new unit into the empty power supply bay and push it completely into the
chassis. Reconnect all the power connectors to the same headers you
removed the old power supply cables from, making sure you reroute the
power cables so that they do not block system airflow. Replace the
chassis top cover and reposition the unit back into the rack. Finish by
reconnecting the power cord and depressing the power button on the
chassis front control panel.