Supermicro SuperServer 6011D, Руководство пользователя

Страница: 36 / 102

5-4
S
UPER
S
ERVER
6011D
User's Manual
Installation
Figure 5-2. Side View of DIMM Installation into Slot
5-4 Installing DIMMs
Please check the following website page to find recommended memory
modules for your Supermicro motherboard:
http://www.supermicro.com/TECHSUPPORT/FAQs/Memory_vendors.htm
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
Memory Module Installation (See Figure 2-2)
1. Install DDR-RAM memory modules into the DIMM slots.
2. Insert each memory module vertically into its slot. Pay attention to
the two notches along the bottom of the module to prevent inserting
the DIMM incorrectly.
3. Gently press down on the memory module until it snaps into place.
4. For the P3TDDR, four DDR-RAM DIMM sockets support up to 4GB of
DDR-RAM. PC1600 and PC2100 memory are both fully supported,
however PC266 is supported at full speed (266 MHz) in three slots
only. If four slots are populated with PC266 it will run at 200 MHz.
5. DDR-RAM speeds should not be mixed. The P3TDDR can use any
configuration of registered-unregistered and ECC-nonECC; however,
it is not recommended that different such configurations be used
across the memory installation.
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Pay attention
to the
alignment
notch.