SuperServer 1029P-NR32R User's Manual
25
Chapter 3
Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
prevent compatibility issues, only use components that match the specifications and/or part
numbers given.
Installation or replacement of most components require that power first be removed from the
system. Please follow the procedures given in each section.
3.1 Powering On the System
Use the procedure below to power on the system.
1. Connect a power cord from a grounded AC outlet to the 1029P-NR32R. Do
not
power
on the system.
2. Press the power button on the 1029P-NR32R, or power on the system using the IPMI
command interface.
3.2 Removing Power
Use the following procedure to ensure that power has been removed from the system. This
step is necessary when removing or installing non hot-swap components or when replacing
a non-redundant power supply.
1. Use either the power button on the control panel or IPMI to power down the system.
2. After the system has completely shut-down, disconnect the AC power cord(s) from the
power strip or outlet. (If your system has more than one power supply, remove the AC
power cords from all power supply modules.)
3. Disconnect the power cord(s) from the power supply module(s).
3.3 Accessing the System
The SC136HTS chassis features a removable top cover, which allows easy access to the
inside of the chassis.
Removing the Top Cover
1. Using a correctly-sized phillips-head screw driver, remove the three screws from the top
panel.
2. When the screws are off, the top panel should come off easily by pulling it upwards.
