Supermicro A+ SERVER 1012C-MRF, Руководство пользователя

Страница: 88 / 116

6-4
A+ SERVER 1012C-MRF USER'S MANUAL
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
DVD-ROM/Serial ATA Drives: For installing or removing the DVD-ROM or SATA
drive, you will need to gain access to the inside of the server by removing the top
cover of the chassis.
Note: Only the optional a "slim" DVD-ROM will fit in the 1012C-MRF.
Serial ATA Drive Installation
The SATA drive is not hot-swappable, meaning system power must be turned off
before installing or removing.
1. First power down the system and then remove the top cover of the chassis as
described on page 6-7.
2. Unscrew the retention screw at the top center of the drive, then push the
drive tray out from the back until you can grasp and pull it out through the
front of the chassis.
3. Remove the drive from the drive tray.
4. To add a new SATA drive, install a drive into the tray with the printed circuit
board side facing down and so that the mounting holes align with those in the
tray.
5. Secure the drive to the tray with the four screws.
6.
Replace the top cover when finished. See Figure 6-3.
Note: The 1012C-MRF can accommodate two internal SATA hard drives, one on
each side of the fans.
Note : Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro
Web site at
http://www.supermicro.com/products/nfo/files/storage/SAS-CompList.
pdf