Supermicro A+ SERVER 1012C-MRF, Руководство пользователя

Страница: 58 / 116

5-6
A+ SERVER 1012C-MRF USER'S MANUAL
5-4 Installing Memory
Caution! Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
Memory Support
The H8SCM-F serverboard supports single and dual channel,
DDR3-1600/1333/1066 Mhz speed registered ECC/Unbuffered ECC/non-ECC
SDRAM. Only interleaved memory is supported, so you must populate two DIMM
slots at a time, one per channel (see procedure above).
Populating two adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Note : Check the Supermicro web site for recommended DIMMs.
Installing Memory
1. Insert each memory module vertically into its slot, paying attention to the
notch along the bottom of the module to prevent inserting the module
incorrectly (see Figure 2-1).
2. Install to slots CPU1/DIMM1A, CPU1/DIMM2A, CPU1/DIMM1B and CPU1/
DIMM2B, etc. Always install in groups of two and in the numerical order of the
DIMM slots. See support information below.
3. Gently press down on the memory module until it snaps into place.
Note: 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size memory modules are
supported. It is highly recommended that you remove the power cord from the
system before installing or changing memory modules. Please refer to our web site
for memory that has been tested on the H8SCM-F serverboard.