Superlift RDO1 C, Инструкция по эксплуатации

Страница: 7 / 15

- 7 -
RDO1 C
GENERAL FITTING REQUIREMENTS
4. LEFT OR RIGHT HAND END INSTALLATION
Your opener has been factory set to be installed on the right hand end of your door (when viewed
from inside the garage looking out) If you will be installing your Opener to the right hand side of then
ignore the instructions outlined in Point 5. If the left hand side is your selected side for installation then
you must carry out the procedure outlined in Point 5 .
5. CONVERTING OPENER FROM RIGHT HAND TO LEFT HAND INSTALLATION
Locate the red and black motor wires. Fig 6 The standard connection (Black to Black and Red to Red) must
be reversed. Unplug the wires at the connectors and reverse them so that they are connected Red to Black
and Black to Red. You can now proceed to step 1 of the Installation Instructions.
Fig 6 Fig 7
6. CONTROL BOX
Mount the control box on a smooth flat surface. The area must be completely free of exposure to water,
either direct (rain, garden hose, sprinklers etc) or indirect (seepage either through or down the internal face
of the wall). The control box contains sensitive electronics which will sustain damage as a result of any
water intrusion. Water damaged electronics are not covered under the terms of the opener warranty.
Important Note: The control box is not water proof!
7. VOLTAGE SELECTION (For non 240 volt markets only)
For certain markets your RDO1 Opener will have been fitted with a switch able dual voltage
transformer. All transformers have been factory pre-set to suit a 220~240 volt power supply . If your
local power supply is 110~115 volt you will be required to switch the transformer power supply leads
inside the Control Box as depicted in Fig 7 . To switch the power supply leads, remove the Control Box
cover. Locate and un-plug the plastic connectors marked “240V” (Black and Brown coloured wires) and
plug-in to the connectors marked “115V” (Black and Blue) coloured wires). The switch to 115 volts is now
complete.