Superlift RDO1 C, Инструкция по эксплуатации

Страница: 11 / 15

- 11 -
RDO1 C
GENERAL FITTING REQUIREMENTS
5. CODING THE TRANSMITTERS
5.1 Remove the hand held transmitter from the packing boxes
5.2 Remove the light cover from the Control Box by pulling at the top edge.
5.3 Locate the transmitter coding button located in the recessed panel within the light cover enclosure Fig
5.4 Press and release this button and the adjacent red LED will glow solid.
5.5 Momentarily press and release the White Button on the Hand Transmitter and the red Led will extinguish
5.6 Momentarily press and release the White Button again and the red LED will flash. Once the flashing stops
the transmitter has been successfully coded.
5.7 Repeat steps 5.3~5.5 to code additional transmitters
6. DELETING PREVIOUSLY STORED CODES
6.1 Switch the power off at the power supply.
6.2 Whilst holding down the transmitter coding button, Fig 3 switch the power back on.
6.3 Continue to hold down the transmitter coding button and the red LED will begin to flash. All of the
previously stored codes will have been deleted once the LED stops flashing.
6.4 To re coded new transmitters follow the sequence outlined in points 5.3~5.6
7. OPEN & CLOSE LIMIT FINAL ADJUSTMENT
7.1 Test the door open and close positions by pressing either the white button on the coded transmitter or the
red external push button located on the front face of the Control Box.
7.2 Check that the door opens and closes to the required positions. If not then re-adjust the Open and/or Close
Limit Cams accordingly.
7.3 Once finally adjusted, firmly tighten the 3 Limit Cam Locking Screws and refit the Limit Cover Plate.
8. OPEN AND CLOSE SAFETY OBSRUCTION FORCE ADJUSTMENT
8.1
Locate the 2 Safety Obstruction Force “SOF” adjustment screws in the recessed panel within the light
cover enclosure. Fig 3 Both of the screws have been factory pre set to the maximum setting (clockwise
direction).
8.2
The upper screw adjust the “SOF” in the OPEN direction of the door travel, while the lower screw adjusts
the “SOF” in the CLOSE direction of door travel.
8.3
Open Direction “SOF” adjustment - With the door in the fully open position - Press the red button located
on the face of the Control Box. As the door commences to close, slowly begin to turn the LOWER “SOF”
screw in an ant clockwise direction until the door stops and reverses towards the Open direction. Now turn
the adjustment back 10 degrees in a CLOCKWISE direction. Note: The door must reverse before it
reaches the ground.
8.4 Test the adjustment by pressing the red button again. This time the door should reach the fully closed
position without reversing.
8.5
Close Direction “SOF” adjustment - With the door in the fully closed position - press the red button on the
face of the Control Box. As the door commences to OPEN, slowly begin to turn the UPPER “SOF” screw
in an ant clockwise direction until the door stops. Now turn the adjustment back 10 degrees in a
CLOCKWISE direction. Note: The door must stop before it reaches the fully open position.