Superlift RDO1 C, Инструкция по эксплуатации

Страница: 5 / 15

- 5 -
RDO1 C
OPERATING CONTROLS
1. PHOTO BEAM ENABLE DIP SWITCH.
2. AUTO CLOSE ENABLE DIP SWITCH.
3. AUTO CLOSE DELAY DIP SWITCHES are used to adjust the time to auto close.
4. SAME AS ABOVE
5. TRANSMITTER CODE BUTTON used for storing or erasing the transmitter button code
6. DOWN FORCE SCREW is used to change the force pressure required to make the door DOWN, if the
door encounters an obstruction.
7. UP FORCE SCREW is used to change the force pressure required to make the door UP, if the door
encounters an obstruction.
8. CODE LED signals the stages of the transmitter code learning process
9. OUTPUT TERMINALS used for connection of photo safety beams or external push button.
10. RADIO RECEIVER processes the signal from the hand held transmitter.
11. AUTO COURTESY LIGHT is activated automatically each time the opener commences an open or close
cycle and remains on for approx 3 minutes
12. OPEN LIMIT CAM is used to adjust the open limit stop position. (Refer to installation manual for correct
use)
13. CLOSE LIMIT CAM is used to adjust the close limit stop position. (Refer to installation manual for
correct use.)
14. OPEN LIMIT MICRO SWITCH is used to stop door in the fully open position.
15. CLOSE LIMIT MICRO SWITCH is used to stop the door in the fully closed position.
16. ENGAGE/DISENGAGE LEVER . Alternatively engages/disengages opener from the door.
17. EXTERNAL PUSH BUTTON alternatively opens, closes or stops the door when activated.
18. VOLTAGE SELECTION TERMINALS switches the input voltage between 115 and 240 volts