SMOKE DETECTORS RECOMMENDED
Since there are always several potential sources
of fire in any home, we recommend installing
smoke detectors. If possible, install the smoke
detector in a hallway adjacent to the room
(to reduce the possibility of occasional false
activation from the heat produced by these
appliances). If your local code requires a smoke
detector be installed within the same room, you
must follow the requirements of your local code.
Check with your local building department for
requirements in your area.
CARBON MONOXIDE MONITOR RECOM-
MENDED
Carbon Monoxide Poisoning
: Early signs of
carbon monoxide poisoning are similar to the
flu with headaches, dizziness and/or nausea.
If you have these symptoms, obtain fresh air
immediately. Some people are more affected
by carbon monoxide than others, including
pregnant women, people with heart or lung
disease or anemia, those under the influence
of alcohol, and those at high altitudes.
It is against federal regulations to operate
wood heaters in a manner inconsistent with
the operating instructions in the manual.
Dealing With a Chimney Fire
Regular chimney maintenance and inspection
can prevent chimney fires. If you have a chimney
fire, follow these steps:
1. Close the fireplace door and the combustion
air controls.
2. Alert your family of the possible danger.
3. If you require assistance, alert your fire
department.
4. If possible, use a dry chemical fire extin-
guisher, baking soda or sand to control the
fire. Do not use water as it may cause a
dangerous steam explosion.
5. Check outside to ensure that sparks and hot
embers coming out of the chimney are not
igniting the roof.
6. Do not use the fireplace again until your
chimney and fireplace have been inspected
by a qualified chimney sweep or a Fire
Department Inspector.
ACHIEVING CLEAN BURNS
Check the exhaust after engaging the catalyst
(see Figure 6)
. Large amounts of smoke indicate
an improper burn setting (either too high, or too
low of a temperature to operate the catalyst).
Adjust and recheck in 5 to 10 minutes.
OK
Figure 6
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
7
FUEL
WHAT DOES “WELL-SEASONED” MEAN?
When a tree is cut down, the wood is green,
full of sap and moisture. This moisture content
can exceed 80%, which must be reduced to
less than 20%. Wood properly seasoned is
then capable of generating the heat the stove
was designed to provide.
Green wood does not burn easily. Attempting to
burn green wood often results in a lot of smoke
and very little fire. Time is the most important
factor in seasoning wood. Ideally the moisture
content should be reduced to 11-20%.
NOTE:
The use of a firewood moisture meter is rec-
ommended to ensure the firewood contains
less than 20% moisture.
Seasoning Guide
Softwoods - 6 months to 18 months
Hardwoods - 12 months to 24 months
Logs that are 5” diameter across or larger should
be split in half, three pieces if over 8 inches, and
four pieces when over a foot across. If a tree
has been dead for 2 - 4 years it still needs to
be cut, split, and seasoned for 6 to 24 months
depending on the wood.
4'
4'
8'
Standard
Cord of
Wood
8 Ft.
(2.4M)
4 Ft.
(1.2M)
4 Ft. (1.2M)
Figure 7
Prohibited Fuels
This heater is designed to burn natural wood
only. Higher efficiencies and lower emissions
generally result when burning air dried seasoned
hardwoods, as compared to softwoods or to
green or freshly cut hardwoods. DO NOT BURN:
• Garbage;
• Lawn clippings or yard waste;
• Materials containing rubber, including tires;
• Materials containing plastic;
• Waste petroleum products, paints or paint
thinners, or asphalt products;
• Materials containing asbestos;
• Construction or demolition debris;
• Railroad ties or pressure-treated wood;
• Manure or animal remains;
• Salt water driftwood or other previously salt
water saturated materials;
• Unseasoned wood;
• Christmas tree branches;
• Paper products, colored paper, cardboard,
plywood, or particleboard;
• gasoline;
• naphtha;
• engine oil;
• flammable liquids;
• solvents;
• grease; or
• coal
The prohibition against burning these materials
does not prohibit the use of fire starters made
from paper, cardboard, saw dust, wax and
similar substances for the purpose of starting
a fire in an affected wood heater.
Burning these materials may result in release
of toxic fumes or render the heater ineffective
and cause smoke. Intense firing with these
materials may overheat the fireplace, causing
damage to the unit, a fire or even possibly ignit-
ing a chimney fire if the chimney is creosoted.
Burning unapproved fuel, resulting in excessive
pollutants being emitted, may be prohibited and
subject to a fine or other penalty by the authority
having jurisdiction in your area.
