40
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l’entretien de
l’appareil doit être remis en
place avant de mettre l’appareil
en marche.
Barrier (see Notice, Page 40)
This fireplace comes with a barrier to reduce the
likelihood of burns from touching hot glass. If
the barrier is damaged, the fireplace should be
turned off immediately and the fireplace must
not be operated until a new, approved factory
barrier for this unit is installed.
To remove barrier follow these steps.
1. Lift barrier up by the frame at the top.
2. Remove lower filler piece by pulling down
off of the barrier.
3. Lower barrier and push barrier to left to
release right side.
4. Pull the right side out of fireplace.
5. Remove screen.
6. Install the new, approved factory barrier
with flat side of screen toward firebox.
To install the front glass door assembly,
proceed as follows:
1.
Retrieve the glass door assembly. Visually
inspect the gasket on the backside of the
panel. The gasket surface must be clean,
free of irregularities and seated firmly.
2.
Position the door frame in front of the firebox
opening and engage the bottom flange over
the rail at the bottom of the firebox opening.
3.
Swing the door up and back. Ensure the
gasket seats evenly as the door draws shut.
Engage the nut insert and fasten with two
screws to secure the door.
4.
Install the door modesty shield on top
flange glass door as follows: grab the door
modesty shield with both hands, with the
open hem going down and engage it with
the upper lip of the glass door frame by
pushing it all the way down. Make sure the
installed shield is firmly in place.
WHEN INSTALLING THE GLASS DOOR,
SECURELY TIGHTEN THE LATCH SCREWS
- SEE THE FIRST WARNING ON THIS PAGE.
When installing the glass door, ensure the
spacing on both sides are equal.
WARNING
The door should easily close
without needing to be pressed
down. If it has to be pressed
down to close, the gasket in the
top of the door should be dressed
so it lays on the glass.
INNOVATIVE HEARTH PRODUCTS • POWER VENT DV GAS FIREPLACES (DRT6340TYN AND DRT6345TYN) • INSTALLATION INSTRUCTIONS
Figure 52 - Front Glass Enclosure
Panel
Top Flange Glass Door
Frame Assembly
Glass Door Latch (2)
Latch
Screws
Firebox Floor
Glass Door Assembly
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
WARNING: DO NOT abuse glass door by
striking or slamming shut.
These are direct-vent appliances. They are
designed to operate only when the front glass
enclosure panel is installed. Generally the front
glass enclosure panel should not be removed
except to gain access to the components within
the firebox.
Removing Glass Enclosure Panel
(see
Figure 52)
Remove the door modesty shield from the top
flange glass door by pulling it up firmly with
both hands until it is disengaged. Using a phillips
screwdriver, unfasten two (2) screws located
at the top of the glass frame.
Tilt the glass frame at the top away from the
unit. Lift it carefully off the bottom door track
and set the door aside, protecting it from
inadvertent damage.
NOTICE:
All DRT/DRC6300
PV Series fireplaces include
a barrier to reduce the risk of
burns from hot viewing glass.
This barrier in the fireplace is
a screen shown below.
40” Barrier Cat. No. J7422
45” Barrier Cat. No. J7423
f i r e - p a r t s . c o m
