Installation
900298-00, 10/2014
Innovative Hearth Products
Superior
TM
DRT/DRC3500 Series Direct-Vent Gas Fireplaces
40
Figure 33: Electronic Pilot
Igniter
Flame Rod
Pilot Hood
Remote Control System
WARNING
Fire hazard. Can cause severe injury or death. The receiver causes ignition of the appliance. The appliance
can turn on suddenly. Keep away from the appliance burner when operating the remote system or activating
manual bypass of the remote system.
CAUTION
Property damage hazard. Excessive heat can cause property damage. The appliance can stay lit for many
hours. Turn off the appliance if it is not going to be attended for any length of time. Always place the
transmitter where children can not reach it.
The remote and receiver allow you to command the functions of your fireplace from the comfort of you chair and
are configured to control the ON/OFF primary burner operation, six (6) flame levels, and provide ON/OFF and smart
thermostatic control. The system controls fan speed through six (6) levels and has a constantly powered 110V/60Hz
power outlet. The receiver is powered by four (4) AA batteries. It accepts commands via radio frequency from the
transmitter and does not require line-of-sight operation. The wall switch can be set to one of three (3) positions:
•
ON (Manual Override)
•
REMOTE (Remote Control)
•
OFF
Initializing the remote control system for the first time
1.
Install the four (4) AA batteries into the wall switch battery bay (behind the switch plate).
NOTE:
Check the polarity (+/-) of the batteries and insert them into the battery bay as indicated on the
battery cover.
2.
Place the three-position slider switch in the REMOTE position (
Figure 48
).
Figure 34: Wall Switch
Figure 35: Transmitter (Remote Control)
Figure 36: Remote Control Display—Indicator Icons
Remote
Off
On
PRG
Three-position slider switch
in REMOTE position
Hot Fireplace Will Cause
Severe Burns
Never Allow Children to
Touch Glass or other Fire-
place Parts
WARNING
LCD Display
ON/OFF Key
THERMOSTAT
Key
UP/DOWN
ARROW
Key
MODE Key
Transmission
Thermostat
OFF/ON/SMART
Set Point
Temp./Level/State
Flame On
Fan Control
Child Safety Lock-Out
Low Battery Alarm
Room
Temperature
Maximum Level
Indicatiors
Light On
3.
Insert the end of a paper clip, or other similar object, into the hole marked PRG on the wall switch front cover.
The receiver will beep three (3) times to indicate that it is ready to synchronize with a transmitter.