SuperiorFireplaces.US.com
900806-00NC
16
INSTALLATION
Continued
Figure 30 - Air Kit Handle Location
Figure 31 - Sealing Between Appliance and Framing
Figure 32 - Installing Optional Glass Door
COMBUSTION AIR KIT MODEL AK4 (OPTIONAL)
The outside air kit may be installed on the left side of fi replace only.
The vent can be installed through any outside wall a minimum of three
feet below fi replace termination cap. The handle to operate damper
door for outside air inlet will be located inside the left “screen pocket”
of fi rebox
(see
Figure 30
)
. Pull handle to open or push to close.
Air Kit
Handle
Screen
Pocket
Side
Framing
Side
Framing
Caulk Here
Pack Insulation
Spring Clip
Insert Pin Into Spring Clip
Insert Bottom Pivot Pin Into Pivot
Plate and Swing Door Into Vertical
Position
Pivot Plate
Slide Top Pin
Into Door Track
APPLIANCE ENCLOSURE
Before fi nishing enclosure around appliance, inspect all joints around
outer surround. Any gaps between nailing fl anges and framing should
be sealed with noncombustible insulation or caulking.
If appliance is mounted on a raised platform, it must be a continuous
surface and not on blocks without a solid surface. This will prevent
the entry of cold air by means of conduction through the total bottom
of appliance
(see
Figure 31
).
CAUTION: Air inlet ducts are not to terminate in
attic space.
CAUTION: Use only glass doors certifi ed for use
with this appliance.
INSTALLING OPTIONAL GLASS DOOR ACCESSORY
NOTE:
Glass door may be heavy for some individuals. Please request
help if needed.
The BRT4036, BRT4336, BRT4536, BRT4042, BRT4342 and BRT4542
B-vent fi replaces are approved for use with optional bi-fold glass doors
(see Accessories,
Page 27
).
Glass panels may be ordered and installed
anytime after fi replace installation is complete.
Follow these steps to install left and right panels:
1. With handle at the bottom, completely fold panel on its hinges.
2. With handle facing center of fi rebox opening, insert lower pivot pin on
glass door panel into hole in pivot plate on bottom edge of fi replace
opening
(see
Figure 32
)
.
3. Keeping folded door tilted, slide upper two pins into guide track
found under upper facial edge of fi rebox opening.
4. Tilt glass assembly fully vertical until outer pivot pin snaps into
mounting hole in upper spring clip
(see
Figure 32
)
.
5. Once top and bottom pins are secured, unfold door into the closed
position.
