SuperiorFireplaces.us.com
126829-01C
24
Figure 40 - Control Knob and Igniter
Button Location
O
F
F
LO
IH
ON
OFF
REMOTE
PIL
OT
O
N
Control Knob
Igniter
Button
Flame
Adjustment
Knob
OPERATION
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
WARNING: Damper handle
will be hot if heater has been
running.
WARNING:
• If fireplace has glass doors,
never operate this heater with
glass doors closed. If you
operate heater with doors
closed, heat buildup inside
fireplace will cause glass to
burst. Make sure there are no
obstructions across open-
ings of fireplace.
• You must operate this heater
with a fireplace screen in
place. Make sure fireplace
screen is closed before run-
ning heater.
NOTICE: During initial operation
of new heater, burning logs will
give off a paper-burning smell.
Orange flame will also be pres
-
ent. Open damper or window to
vent smell. This will only last a
few hours.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don’t try to repair it, call a quali-
fied service technician or gas supplier.
Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
LIGHTING
INSTRUCTIONS
FOR YOUR SAFETY
READ BEFORE LIGHTING
NOTE
: Homeowners generally prefer to operate
their heater with the chimney damper closed.
This will put all the heat into the room. However,
there may be times you will desire the full flames
of the HI heat setting but will find the heat output
excessive. You can open the chimney damper (if
you have one) fully or partially to release some
of the heat.
1. STOP! Read the safety information.
2. Make sure equipment shutoff valve is fully
open.
3. Press in and turn control knob clockwise
to the OFF position
(see
Figure 40
).
