SuperiorFireplaces.us.com
126829-01C
22
INSTALLATION
Continued
1.
Ember Chunk Placement.
The
BGE2436 burner systems include three
ember chunks that are designed to fit
over shoulder screws on the ember pan
burner. The bottom of each ember chunk
has a hole for securing the ember chunk
in place when it is placed over a shoulder
screw. Place the ember chunks as shown
in
Figure 37
on
Page 23
by placing the
ember chunk with the number "1" on
the left, "2" in the center, and "3" on the
right. These numbers are embossed on
the back of each piece for identification
purposes. Please note that BGE18 burner
systems do not include ember chunks.
2. Two ember materials are supplied with
this log set. Platinum Bright Embers give
a bright glow appearing as hot coals.
Follow instructions for the ember material
you choose. Should embers need replac-
ing, see
Parts
,
Page 37
.
Platinum Bright Ember placement.
Add
embers to front, flat burner. Gently remove
embers from bag. Separate pieces of
ember material and place on surface of
flat burner just behind horizontal ports as
shown in
Figure 38
.
Glowing Embers (rockwool) place
-
ment.
Place glowing ember material on
front flat burner in areas away from ports
as shown in
Figure 39
.
3. Add volcanic stone and small decorative
logs around base of heater if desired.
DO
NOT place volcanic stone or additional
logs on front burner or on logs.
Plac-
ing any material on unit other than ember
material on front burner may result in pro-
duction of carbon monoxide or soot. Use
volcanic stone to hide wires from switch/
log to control valve. Place switch/log so
the switch is easy to access.
WARNING: Do not use any
other ember material not sup-
plied with this unit.
WARNING: All previously
applied loose material must be
removed prior to reapplication.
WARNING: Do not operate
unit without ember material
correctly in place as shown in
Figures 38 & 39
. Do NOT place
ember material anywhere else on
the unit. Use only ember material
supplied with unit. Excessive
or incorrectly placed ember
material may produce carbon
monoxide or soot. If replace-
ment embers are needed, the
replacement embers must be
purchased from IHP. See
Page
37
for part numbers.
EMBER PLACEMENT - BGE SERIES
BURNER SYSTEMS
Figure 36 - Installing Top Rear Log
Top Rear
Log
Rear Log
12. Place the top rear log (18" D-071, 24" &
30" D-045) onto the rear log as shown. The
rear log has a projection that will fit into the
recess area on the bottom of the top rear
log
(see
Figure 36
).
If replacement embers are needed,
the replacement embers must be
purchased from IHP. See
Page 37
for part numbers.
