SuperiorFireplaces.us.com
126829-01C
18
INSTALLATION
Continued
FIBER LOG MODELS
LBG(18,24,30,36)SM
NOTE
: Your appliance may vary from model
shown but log placement will be the same.
1. Place bottom log in center of the base
assembly as shown in
Figure 21
. The
log must sit flat on the black metal sheet
and behind the left metal tab as shown in
Figure 20
.
Rear Log
Grate
Prongs
Figure 21 - Installing Log Set
Bottom Log
Base Assembly
Front
Right Log
Front Left
Log
Figure 22 - Installing Log Sets
Middle Right Log
Middle
Left Log
Bottom
Log
Pin on Front
Left Log
Figure 23 - Installing LBG36SM Model
Control Cover Logs
Left Control
Cover Log
Right Control
Cover Log
Right Small Front Log
Left Small
Front Log
Bracket
Bracket
Figure 20 - Installing Log Set
Ramp
Log
Metal Tab
2. Rest rear log in back corner sections of
base assembly as shown in
Figure 21
.
Make sure log is completely vertical and
not leaning in toward burner where flame
will touch the log.
3. Position front right log against right side
of grate prongs
(see
Figure 21
).
4. Position front left log against left side of
grate prongs
(see
Figure 21
)
.
5. Place middle right log over front right and
bottom logs as shown in
Figure 22
. Be
sure hole in middle right log seats over
pin in bottom log.
6. Place middle left log over front left and
bottom logs as show in
Figure 22
. Be
sure hole in middle left log seats over pin
in front left log.
7. For LTF36SM, the front right and left
logs are longer and are supported with
brackets on each end
(see
Figure 23
)
.
Place left and right small front logs under
left bracket and beside right bracket.
