Superabrasive LAVINA 38GR -X, Руководство пользователя

Страница: 17 / 58

Superabrasive
Owner’s Manual Original Language – Lavina
®
38GR-X 08/2017
17
STARTING THE MACHINE
NEVER WORK WITH THE MACHINE WITHOUT VISUAL CONTACT WITH IT .
ATTENTION : Never run the machine when situated between the handles of the
wheel. Turn the handles as shown in Fig.4.15 before starting.
If working wet, wet the floor surface. If working dry, instead connect and start the
vacuum cleaner.
First, follow the directions listed in "Safety Devices and 'SAFETY
INSTRUCTIONS'". Check oil level. Open the service valve on the propane tank
about one and a half turns (counterclockwise). Turn the switch (Fig.4.11-1) to
"Remote" and switch
Ready to "ON" and wait to light - there will be a warning
sound signal. Next, ensure that the Start/Stop clutch button (Fig.4.10-4) is in stop
position. Check that the throttle (Fig.4.11-7) is in the IDLE position. Check the
"emergency stop" button (Fig.4.11-6) to be sure that the machine is in working condition.
To start the engine, press "Motor on" (Fig.4.10-10), hold until the engine starts, then release - the warning sound signal
should stop. Set the required speed (Fig.4.10-8), push " Clutch ON" and choose the desired direction with the joystick
(Fig.4.10-6).
OPERATING THE MACHINE
Guide the machine in straight lines across the floor, slightly overlapping the previously completed surface with each new
line. Work at a constant speed,
allowing the tools time to work at a speed appropriate for the tools’ grit size. Avoid
vibrations. Do not stop the machine while tools are still running as they will mark the surface of the floor. When working
wet, select the destination of the water feed with the water tap (Fig. 4.2-1) and periodically run the pump (Fig. 4.10-11)
to release water onto the floor surface. Starting the pump is possible only if the machine motor is on. When working dry,
check the floor surface periodically to for dust accumulation. Check regularly to see if your vacuum works properly. If
needed, lights may be turned on via the switch on the remote control panel (Fig.4.10-5).
STOPPING THE MACHINE
The machine can be stopped by moving the joystick opposite the moving direction.
To prevent damage to the floor surface, do not stop the machine before stopping the motor. The motor should
have completed stopped rotating before stopping the machine.
To stop the machine engine, use the "Motor off" switch. Only use the "Emergency Stop" button in case of
emergency.
This will activate the buzzer with the warning sound signal announcing the battery mode.
At this stage, turn the
Ready switch (Fig. 4.11-3) to the "OFF" position to stop the power supply to the machine.
NOTE! Do not hold the machine in one spot before the engine stops to turn.
ALARM
The machine stops when the emergency stop button is activated or the inverters are shut down by emergency.
It is indicated by flickering lamp built into the Ready
"ON/OFF” switch
The control panel display will show " Emergency stop " or " Inverter fault ". After eliminating the cause of the
accident, the machine can be reset to working condition by releasing the emergency stop or turning on the "Inverter
reset"( Fig.4.10-3).
The lighting of the "BATTERY" lamp during operation of the engine indicates faults in the battery charging
system.
Extinction of the "FUEL " indicator lamp during operation or lack of light during the ignition to start the engine
indicates a faulty valve of incoming gas or low oil level in the engine.
Figure 4.15