Suntex CT-6110-POL, Руководство по эксплуатации, Страница: 44 / 80

7.13 Clean/Auto Zero
Enter setup of “Clean/Auto Zero” function. Select the icon to turn on or turn off the clean function. If
you select “Auto” turning on, then set as clean or auto zero function, and then set timer of the
clean/auto zero function including automatically turning on timer and turning off timer, and set the
Hysteresis timer(Hys.). (Please refer to ch2.3.2 for external piping configuration.)
Note: When the clean/auto zero function is turned on, if any value is set to be 0, the instrument will
automatically turn off this function. When the clean/auto zero function is activated under measurement mode,
there is a “Clean Running” or “Auto Zero” message showing on top of the display. The measurement value
will be remained at the last measured value before cleaning. If enter setting menu or calibration menu under
clean status, the instrument will stop clean/auto zero procedure automatically.
Press or
to adjust the auto
turning on time.
Press to confirm
the minute part, and
move to adjust the
second part.
on off on off on
off off
on on
off
T
on
T
hys
T
off
T
on
T
hys
T
off
T
off
Cln/Auto Zero Timer Control
Relay
Contact
Timer
Settings
Measure
Action
Enter “Analog” Setup
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press or to
select to activate a test of
Cln/Auto Zero or not. If
“ON”, the Clean/Auto
Zero function is in action,
and the “ACT” indication
light will light up.
Press or
to select to activate
Cln/Auto Zero or
not. If not, the
guide menu goes to
setup of Analog.
Press to confirm it.
Press or
to adjust Hysteresis
(Hys.) time. Press
to confirm the
minute part, and
move to adjust the
second part.
Press or
to select Clean or
Auto Zero function.
Press or
to adjust the auto
turning off time.
Press to confirm
the hour part, and
move to adjust the
minute part.
40