10
•
Note that the red capped blade and blue capped blade have a cutback on the opposing side of the blade
(right side, in the earlier photo). This reduces the blade offset value and allows for better detailed cutting of
small shapes.
•
Additionally, there are other tools sold separately, including a stand, an engraving tool and an
embossing/scoring tool. Details on the engraving tool and embosser are covered in
Chapter 4.
1.07.3 Blade Installation
•
The blade must be carefully inserted into the blade holder. Do this over a soft surface (e.g. over a hand
towel). It’s important to protect the fragile blade! To install, follow the numbered steps as shown:
•
The
Blade Length
(also called
Blade Exposure
) is how much blade is exposed at the bottom of the blade
holder. For optimal cutting, you want this length to match the thickness of the material or be just a tiny bit
longer.
•
When setting the blade length (
Step 4
in the prior photo), hold the blade holder up next to the material
before pressing the material to the mat, so that you can more accurately set the length to match the
thickness of the material. For really thin materials, like vinyl and thin paper, just the very tip of the blade will
be protruding from the bottom of the blade holder. In fact, you should just barely be able to feel it with your
fingertip and not be able to see it very well, if at all. Having the blade fully extended will never result in better
cutting. In fact, it can cause skewing, tearing of the material, damage to the blade, and damage to the mat.
•
A good way to test your blade length is to fold a piece of the material onto itself and then cut a line into the
material by hand. Press firmly but not too hard, as more force will not determine if the blade is set to the
right length. If the blade cannot cut through the material, you will need to extend the blade. If the blade cuts
through the material and cuts into the next layer, you need to retract the blade. If the blade cuts through the
material but does not cut into the layer below, you have the perfect length.
•
When conducting a test cut, be sure to check your mat (or the top of a backing sheet) for cut lines after the
test. You should be able to set the length to get clean cuts but with only fine lines or no lines in the mat or
backing sheet. If you do see deep cut lines, retract the blade length ~¼ of a turn counterclockwise. Repeat
your test cut.
3. Turn the brass ring
counterclockwise until
loosened.
4. Turn the large ring clockwise or counter
clockwise to set blade length to match the
thickness of the material being cut.
5. Turn the brass ring clockwise
until locked back in place.
1. Push in this button
and hold so that a blade
can be inserted OR
removed.
2. Gently insert non-sharp end
of the blade into the holder.
An internal magnet will pull
the blade inwards.
Then release button on top of
holder
Mat
Material
Perfect Length
Too Long
Too Short
