Sunquest PRO 24RS, Инструкция по сборке и эксплуатации

Страница: 19 / 23

15
Care & Maintenance-Replacing Lamps
Removing/Replacing Face Tanner Lamp
on F Models
After removing the canopy acrylic shield,
replace the face tanner lamp as follows:
Step 1. Support the face tanner assem-
bly with your hand while
unscrewing the two retaining
screws. The face tanner glass
casing will now swing down-
ward.
Step 2. The lamp can now be
exchanged. The lamp holders
are equipped with spring con-
tacts which enables the lamp to
be removed easily. Remove the
old lamp and discard. Install the
new lamp, using a clean cloth or
paper towel. Ensure that the
lamp is firmly seated in the lamp
holders.
RETAINING
SCREWS
Note! Never take hold of the lamp such
that your fingers are in contact with the
lamp glass. Finger oils will greatly reduce
the lamp’s operational life.
Step 3. Gently close the face tanner
glass casing and lock it closed
with the screws. Ensure that the
screws firmly secure the glass
casing.
Warning! Never turn the equipment on
while the face tanner is disassembled or
when the glass filters have been moved.
The direct light can cause severe injury to
the eyes and to other areas of the body.
Immediately discontinue use of this
equipment if the face tanner glass is bro-
ken or if any unfiltered light can be seen
escaping the face tanner assembly.