Sunquest PRO 24RS, Инструкция по сборке и эксплуатации

Страница: 15 / 23

11
Operation-Using Your Sunbed
Using Your Sunbed
Once you have read Before You Tan and
Exposure Times , you are ready to use your
sunbed. Proceed as follows.
WARNING! Your sunbed is designed for
individual use. Only one pair of protec-
tive goggles is provided.
Always wear
these or another approved pair of gog-
gles. Regular sunglasses
do not provide
adequate protection from ultraviolet
light. You should never look at the lamps
when turned on without wearing the
appropriate protective goggles.
Step 1. For units equipped with a face
tanner, activate the face tanner
by placing the rocker switch
located next to the timer knob
into the
“ I ” (ON) position. If you
do not wish to use the face tan-
ner, leave the switch in the
“ O ”
(OFF) position.
Note! The F model face tanner
lamps need a longer after-use
cooling period before they will
light up again.
Step 2. Set the timer to the desired
number of minutes (after first
determining the proper time
period from the table on page
10). The lamps will turn on as
soon as you move the rotary dial
from the
“ 0 ” position.
OFF
20
15
10
5
0
C
O
O
L
D
O
W
N
Step 3. Lift the canopy, lie down on the
bench (face up), and lower the
canopy toward your body. For
best results, position the canopy
as close as possible to your body,
but
do not bring the canopies
with face tanners any closer
than 1 inch from your body.
Step 4. When the timer reaches 0, the
lamps will automatically turn off.
The cooling fans run for 3 min-
utes after the lamps shut off to
aid in cooling the sunbed. This
cool down cycle is controlled by
the timer and is indicated on the
timer plate as
“ Cool Down ” . You
will notice that the timer will
continue to count down to the
“ Off ” position. At this time, the
fans will shut off.
FACE TANNER ROCKER SWITCH