12
are & Maintenance
C
Cleaning After Use
Clean and disinfect your tanning bed’s
bench and canopy after each use. Use a
non-abrasive disinfectant cleaner that
does not contain ammonia or ammonia
derivatives
. Ammonia may damage the
acrylic shield. Spray the acrylic lightly
with disinfectant and wipe dry with a
clean soft cloth. We recommend
SunQuest
®
disinfectant and
SunQuest
®
acrylic cleaner.
Thorough Periodic Cleaning
Introduction
The cooling fans draw air through the bed
and over time will cause a dust buildup
on the lamps and reflectors. This will
reduce the tanning effectiveness of the
bed. When a dust buildup is observed, it
is necessary to thoroughly clean the
inside of the bench and canopy.
Warning!
Disconnect sunbed from elec-
trical power before cleaning.
Cleaning the Canopy and Bench
Step 1.
Remove the acrylic shields and
lamps as described in
Replacing
Lamps
.
Step 2.
With a soft cloth, wipe the entire
length of each lamp to remove
any film buildup.
Step 3.
Clean both sides of the acrylic
shields with a non-ammonia dis-
infectant cleaner.
Step 4.
Wipe the reflectors with a clean
damp cloth.
Step 5.
Re-install the lamps and acrylic
shields.
Mechanical Inspection
Your tanning bed has been built for years
of service. To ensure trouble-free opera-
tion throughout its life, inspect the unit’s
mechanical integrity every 400-500 hours
of use.
• Inspect the unit’s fasteners verifying
that all are firmly in place. Pay partic-
ular attention to the hinge bolts.
• Inspect gas springs for signs of wear.
Gas springs that will not hold the
canopy in the full open position
when raised should be immediately
replaced.
• Inspect the timer as indicated in this
manual under
Timer Maintenance
.
• Inspect the AC power cord and its
connections.
• Inspect the acrylic. Broken, cracked
or badly scratched acrylics should be
immediately replaced.
Содержание PRO 24RS
Страница 22: ...18 Notes ...
