November
2015
Fig.16:
Slide PC panel 1 (left) (O1) into the top section created by Bar 1 (corner) (M1) and Bar 2 (middle) (M2). Repeat this step for PC panel 2
(right) (O2) and PC panel 3 (middle) (O3). Repeat for opposite side. Once the polycarbonate panels are installed, remove the protective film.
Fig.17:
Insert Connector 6 (left) (T1) into the slot created by Bar 1 (corner) (M1) and Bar 2 (middle) (M2). Repeat this step for Connector 7 (right)
(T2) and Connector 8 (middle) (T3).
Fig.18:
Insert Steel panel 1 (left) (O4) into the slot created by Bar 1 (corner) (M1) and Bar 2 (middle) (M2). Repeat this step for Steel panel 2 (right)
(O5) and Steel panel 3 (middle) (O6). Repeat for opposite side.
Fig.19:
Attach Beam 2 (outside, lower right corner) (Q2) to Connector 4 (J2) using M6 x 15 mm bolts (AA) and M6 washers (BB) to secure Steel
panel 1 (left) (O4). Repeat this step for Beam 1 (outside, lower left corner) (Q1) to Connector 4 (J2) using M6 x 15 mm bolts (AA) and M6 washers
(BB) to secure Steel panel 2 (right) (O5).
Fig.20:
Attach Beam 3 (outside, lower left middle) (Q3) to Connector 3 (J1) using M6 x 15 mm bolts (AA) and M6 washers (BB) to secure Steel
panel 1 (left) (O4).
Fig.21:
Hang Bracket 1 (long, left) (K1), Bracket 2 (long, right) (K2), Bracket 3 (short, left) (K3), Bracket 4 (short, right) (K4) onto Gutter 1 (long, left)
(D1), Gutter 2 (long, right) (D2), Gutter 3 (short, left) (D3) and Gutter 4 (short, right) (D4) as per above fig.
Fig.22-1:
Attach Bracket 1 (long, left) (K1) and Bracket 2 (long, right) (K2) to Bar 2 (middle) (M2) using M6 x 15 mm bolts (AA) and M6 washers
Fig.22-2:
Attach Bracket 4 (short, right) (K4) to Bar 2 (middle) (M2) using M6 x 15 mm bolts (AA) and M6 washers (BB).
Fig.23:
Connect Bracket 3 (short, left) (K3) and Bracket 4 (short, right) (K4) to Decorative groove connector (R) using M6 x 15 mm bolts
(AA) and M6 washers (BB). Repeat this step for connecting Bracket 1 (long, left) (K1) and Bracket 2 (long, right) (K2).
Fig.24:
Attach Connector (corner) (E) to the top of Post (B). Then secure it to each corner formed by Bracket 1 (long, left) (K1), Bracket 2
(long, right) (K2), Bracket 3 (short, left) (K3), Bracket 4 (short, right) (K4) using M6 x 45 mm bolts (FF) and M6 washers (BB).
