Sunbeam ALPINE I SERIES: APLINE II SERIES, Руководство по ремонту, Страница: 392 / 413

WSM. 124
Section O (Body)
BONNET-To remove
Alpine (Fig. 27)
Support the bonnet lid with a suitable sling In the
open position.
Remove the four setscrews with their washers
from each hinge. (I)
The bonnet lid is now free to be removed.
To refit, reverse the above instructions.
BONNET LOCK-To remove (Fig. 28)
Rapier
Take out the two bolts with their spring and flat
washers (I), (Fig. 26),
Gently ease the lock out of its aperture and release
the operating cable.
With the cable released from (A) pull slightly up on
the lock to gain access to (7). Remove this to
free lever (8) and take out lock.
To remove striker, undo the locknut from above
the baffle into which the unit fits, and turn in an
anti-clockwise direction by the screwdriver slot
provided.
Replace both striker unit and lock by reversing
the above procedure.
Adjustment of the striker is carried out by screwing
in or out of the striker pin, finally locking up with
the locknut.
Fl1, 27
Bonnet and lock attachment
points
(A/pine)
I.
2.
3.
4.
5.
6.
7.
1st
re-issue
Page 21
Fig. 28. Components
of the bonnet lock
(Rapier)
CATCH 8. LEVER
PIN
9. BRACKET
BUSH
10.
BUSH
WASHER
11. BOLT
NUT
12.
WASHER
CONTROL CABLE
13. NUT
CLIP
When correctly adjusted, a slight movement is
perceptible in the bonnet top when It is in the
closed position.
Fi1, 29.
Bonnet lock striker
(A/pine)