Sunbeam ALPINE I SERIES: APLINE II SERIES, Руководство по ремонту, Страница: 331 / 413

RO OTES MAN UAL WSM. 124
Section N (Elec. Equipment)
due to unclean contacts. If the reading is too high
or too low, an adjustment must be made. In this
event, continue as follows:-
7. Using the correct tool, turn the current ad­
justment cam (clockwise to raise the setting
or anti-clockwise to lower It) until the correct
setting Is obtained.
8. Switch off and restore the original connections.
9.
Refit the cover.
CUT-OUT RELAY
Electrical Settings
I. Cut-In Voltage:
2. Drop-off Voltage:
12·6--13·4
9·3-11·2
Method of Cut-in Adjustment
Checking and adjusting should be completed as
rapidly as possible to avoid heating errors.
I. Connect a first-grade 0--20 moving coil volt­
meter between control box terminal "D" and
CUT-OUT CURRENT VOLTAGE
RELAY REGULATOR REGULATOR
I
st re-issue
Page 14C
a good earthing point. A convenient method
of making this connection to terminal "D"
is to withdraw the ignition warning light feed
from control box terminal "WL" and to clip
the voltmeter lead to the small terminal blade
thus exposed-this terminal being electrically
common with terminal "D".
2. Switch on an electrical load, such as the head­
lamps.
3. Start the engine and slowly increase the engine
speed.
4. Observe the voltmeter pointer. The voltage
should rise steadily and then drop slightly at
the instant of contact closure. The cut-in
voltage is that indicated Immediately before
the pointer drops back. If the cut-In occurs
outside the correct limits, an adjustment must
be made. In this event reduce the engine
speed to below cut-In value and continue as
follows:-
5. Remove the control box cover.
6. Using the correct tool, turn the cut-out relay
adjustment cam until the correct setting Is
obtained-turning the tool clockwise to raise
the setting or anti-clockwise to lower It.
EXTERNAL CONNECTION5 SHOWN IN POKEN UN£
FIELD R£smoft
Fig. 13A.
Current-voltage control box ond internal wiring diagram