sunair RT-9000C, Руководство по эксплуатации и обслуживанию

Страница: 277 / 393

Document No. 8128000560
Software Revision – N1B (07 Oct 04)
7-45
RT-9000 B
If you wish to continue clearing ALL RT-9000 B ALE Identity information, proceed as follows. Using the
appropriate keys in the Numeric and Function Keypads, key in the following three (3) keystroke sequence:
As each character of the sequence is keyed in, it will appear in the Operational Display. After the last
character has been entered, a ‘CLEARING ALE DATA’ message will appear. After this message clears, all
ALE Identity information will now be cleared.
NOTE: The User is strongly advised to become fully familiar with this “Clearing“
function and its effect before using. Once activated, its action is
permanent and cannot be reversed. If used mistakenly, substantial time
may be required to re-enter deleted settings.
7.3.3.8 ‘I/O’ PORT SET-UP
This section describes how to set up the RT-9000 B to automatically communicate with external modems and
remote lines. The RT-9000 B Transceiver has two (2) data ports. These data ports are designated “Port” A
and “Port” B and may be used simultaneously. Both ports physically terminate in the same DB-15 male
connector mounted on the rear panel. This connector is designated as ‘REMOTE’ and is shown in Figure
7.3.3.13.
While unrelated to this I/O Port function, a third port also terminates in this connector. This port is a dedicated
port for the AMD “Auxillary Terminal” and is part of the ALE function. Refer to section VI of this manual for
details.
Figure 7.3.3.13 RT-9000 B Rear Panel Connectors
ALE
Ä
0
ALE
Ä