sunair RT-9000C, Руководство по эксплуатации и обслуживанию

Страница: 296 / 393

Document No. 8128000560
Software Revision – N1B (07 Oct 04)
7-64
RT-9000 B
Figure 7.3.4.12 CALL ID Selection Displays
When the above information initially appears in the Operational Display, the blinking cursor will be
positioned in “CALL ID (Time Slot Position) Number” portion of the above displayed information. The
user should now rotate the ‘TUNING’ knob at
6 until the desired “CALL ID (Time Slot Position)
Number” appears. Using the cursor right arrow ( → ) at 17 , the user now should move the cursor to
the first character position of the CALL ID “Name” portion of the above displayed information. Only
the numbers ’01’ through ‘10’ are valid selections.
NOTE: Under certain conditions, it is possible to display numbers from “11” to
“19”. These numbers are not valid selections and should not be used.
NOTE: When setting up an ALE Network, the Network Time Slot Position
assignments should first use Time Slot One, then Time Slot Two next
and so on until all Time Slot Assignments have been completed. There
should be no unused Time Slots between the SELF ID and any of the
CALL IDs. Failure to observe this precaution may result in incorrect
operation.
If there is information other than dashes
(
-- --
) in the CALL ID Name positions or the user is changing
the current CALL ID Name, depress the 'CLEAR' feature select key to clear the positions and ease
new name entry.
The first position, or dash (
--
) will flash to indicate the specific position where a user selected
character is to be entered. If the first character is satisfactory as is, depressing the right arrow (—>)
key at
17 will move the flashing cursor one position to the right. Alternately, depressing the left arrow
(<—) key at 17 will move the cursor one position to the left.
As each character position is selected, characters '0' through '9' and 'A' through 'Z' may be selected
by rotating the 'TUNING' knob at
6 either clockwise or counter-clockwise. Once the desired
character appears in view, depress the right arrow key (—>) at 17 . The flashing cursor will move to
the next character position. The character selection process is repeated until the desired Network
Station CALL ID Name has been formed.
C XX
-- -- -- -- -- -- -- -- -- -- -- -- -- -- --