Sun Oracle Fire X4440, Руководство по обслуживанию

Страница: 93 / 222

Chapter 4 Servicing Motherboard Components 4-29
3. If necessary, review the PCIe Card Guidelines to plan your installation.
See Section 4.5.1, “Sun Fire X4440 PCIe Card Guidelines” on page 4-25 for
additional information.
4. Remove the PCIe riser board.
See Section 4.4, “Servicing PCIe Risers” on page 4-21 .
5. If the server has been continously used for an extended time, inspect the slot for
particles.
Clean the slot with filtered, compressed air, as required.
6. Remove the PCI filler panel. (
FIGURE 4-14
[1])
PCIe filler panels are located in the motherboard rear panel.
7. Insert the PCIe card into the correct slot on the PCIe riser board. [2]
8. Replace the PCIe riser. [3]
See Section 4.4.2, “Installing a PCIe Riser” on page 4-23 .
a. Slide the riser back until it seats in its slot in the rear panel.
b. Tighten the captive No. 2 Phillips screw securing the riser to the
motherboard.
9. Replace the rear panel PCI crossbeam. [4]
a. Slide the crossbeam down over the PCIe risers.
b. Secure the PCI crossbeam is secured with two captive Phillips screws.
10. Connect any data cables required to the PCIe card.
Route data cables through the cable management arm.
11. Return the server to operation.
a. Install the top cover.
See Section 6.1, “Installing the Top Cover” on page 6-2 .
b. Slide the server into the rack.
See Section 6.3, “Returning the Server to the Normal Rack Position” on
page 6-4 .
c. Reconnect the power cord (or cords) to the power supply (or supplies).
Verify that the AC Present LED is lit.
See Section 6.4, “Powering On the Server” on page 6-6 .
d. Power on the server.
See Section 6.4, “Powering On the Server” on page 6-6 .