Sun Microsystems Fire X4540, Руководство администратора

Страница: 48 / 154

34 Sun Fire X4500/ X4540 Servers Administration Guide • October 2008
3. Verify that Solaris2 fdisk has been created on the same disk.
For additional information about converting EFI and SMI disk labels, refer to the
Solaris 10 Systems Administration Guide at:
http://docs.sun.com
Adding Disks
This assumes you have physically inserted a disk and now want to bring the
inserted disk online.
If you are replacing a mirrored bootable disk, you should use the Solaris Volume
Manager to enable the disk. For additional information, refer to the
Solaris Volume
Manager Administration Guide (819-2789).
Note –
You should predetermine which attachment point the disk is being inserted
into before inserting the disk. Refer to
FIGURE 8-4
for a listing of disk drives.
1. Determine the attachment point by typing the following command:
# fdisk /dev/rdsk/c0t7d0p0
Total disk size is 30400 cylinders
Cylinder size is 16065 (512 byte) blocks
Cylinders
Partition Status Type Start End Length %
========= ====== ============ ===== === ====== ===
1 Active Solaris2 1 30399 30399 100
SELECT ONE OF THE FOLLOWING:
1. Create a partition
2. Specify the active partition
3. Delete a partition
4. Change between Solaris and Solaris2 Partition IDs
5. Exit (update disk configuration and exit)
6. Cancel (exit without updating disk configuration)
Enter Selection: 5
The above display confirms that the Solaris2 fdisk has been created.
#
cfgadm > cfgadm_snapshot