Sun Microsystems Fire V125, Руководство по установке

Страница: 25 / 30

Chapter 3 Powering On and Configuring the Server 13
▼
To Power On Using the On/Standby Button
Caution –
Never move the system when the system power is on. Movement can
cause catastrophic hard drive failure. Always power off the system before moving it.
1. Connect the server to the power supply.
The server automatically goes into Standby power mode when it is connected to a
power source.
2. Turn on power to any peripherals and external storage devices you have connected
to the server.
Read the documentation supplied with the device for specific instructions.
3. Open the front bezel.
4. Press the On/Standby button.
5. Close the front bezel.
Configuring the Server
The Sun Fire server ships with the Solaris 10 OS and the Java Enterprise System
preinstalled on the hard drive. When you power on the server for the first time, a
series of questions leads you through the configuration procedure. This procedure
consists of a number of questions. The answers you give determine how the server is
configured.
In OpenBoot PROM 4.22.17, diagnostics are enabled by default. This ensures
complete diagnostic test coverage on the initial boot and after error or reset events.
This change results in increased boot time. To change the diagnostic settings after
the initial boot and after you configure the server for the first time, refer to
OpenBoot
PROM Enhancements for Diagnostic Operation .
Choose the configuration that best suits your requirements from the list below and
follow the instructions in the appropriate section to power on and configure your
server.
■
“To Configure With the Server’s Details Registered at a Name Server” on page 14
■
“To Configure Without the Server’s Details Registered at a Name Server” on
page 14
■
“To Configure a Standalone Server for the First Time” on page 15
■
“To Clear the Configuration” on page 16