Sun Microsystems Blade X6275 M2, Руководство по обслуживанию

Страница: 39 / 136

Note –
The Sun Blade X6275 M2 Server module is a dual-node server. If necessary, use this
procedure for both nodes.
Prepare the server module for service. See “How to Prepare the Server Module for Service”on
page 25 .
Remove the service processor (SP) board. See “How to Remove the Service Processor Board”on
page 53 .
To dislodge the battery from its holder, gently push the top edge of the battery away from the
battery holder.
See frame [1] in “Battery Replacement Illustration” on page 37 .
Remove the battery.
See frame [2] in “Battery Replacement Illustration” on page 37 .
Orient the new battery so that the '+' symbol faces away from the battery holder.
To install the battery, insert it into the holder and press it into position.
See frames [3] and [4] in “Battery Replacement Illustration” on page 37 .
Install the SP board. See “How to Install the Service Processor Board”on page 54 .
Clear the CMOS NVRAM. See “Clearing CMOS NVRAM and Resetting Passwords”on page 79 .
The BIOS settings revert to the default settings.
See “Clearing CMOS NVRAM and Resetting Passwords” on page 79 .
To customize the BIOS settings, access the BIOS Setup Utility and make the necessary changes.
See
“How to Configure the BIOS Using the BIOS Setup Utility”on page 95 .
Prepare the server module for operation. See “Preparing the Server for Operation”on page 34 .
Removing and Installing DIMMs
This section describes how to diagnose and replace faulty DDR3 LV DIMMs.
Note –
This component is a customer-replaceable unit (CRU).
Use these topics procedures to remove and install DIMMs:
1
2
3
4
5
6
7
8
9
10
Removing and Installing DIMMs
39