Sulzer Metco ECO ARC 600, Руководство пользователя

Страница: 51 / 94

ECO ARC 600
5-5
Revision 1/10/08
5.3 Starting the system
Before you can operate the ECO ARC 600, please note the following:
• Check level of oil in the oiler (13).
The level has to comply with the marks at the oiler.
For refilling push down the retainer at the oiler and take out the
protective grid including the glass plunger. After refill lock both
component with the oiler.
• Check filter insert in drain valve (14).
Filter insert must not be stained or blocked, otherwise the supply of
compressed air is not guarantied for the system.
• Check all connections.
Loose cable connections lead to charring of cable.
• Ventilation and exhaust must be online while spraying at all times.
To set-up the system completely, following steps have to be done:
• Switch on power supply with main switch (6).
White signal lamp (1) lights permanently, yellow signal lamp (3) is
blinking.
• Push yellow button (3) once to acknowledge.
White (1) and green signal lamp (2) light permanently.
• Push the wire feed button (4) until wires come out of the contact
nozzles.
• Cilp off wire tips at the contact nozzles shortly.
The wire tips should not touch each other.
• The system is set-up completely.
If the system is allready set-up, following steps have to be done:
• Direct and lock hand spray device into exhaust.
• Open compressed air supply.
• Switch on power supply with main switch (6).
White signal lamp (1) lights permanently, yellow signal lamp (3) is
blinking.
• Push yellow button (3) once to acknowledge.
White (1) and green signal lamp (2) light permanently.
• Adjust spray voltage step switch (8) according to used wire.
(s. Setting-up spray voltage)
• Caution!
Never switch voltage step switch while spraying.
• Hold the dead-man switch (B) at the spray device.
Push the ON-button (A) at the spray device.