Sullivan-Palatek 15D, Руководство пользователя

Страница: 57 / 114

49 MAINTENANCE
4.
Remove any remaining oil by turning the compressor unit by hand.
5.
Remove oil filter element.
FLUSH COMPRESSOR
1.
Pour as much flush lubricant into the inlet as was removed from the compressor.
2. Add flush lubricant to the sump tank to maximum fill level.
3. Install a new oil filter element and jog compressor.
4.
Run the compressor at normal operating conditions for two days to two weeks.
5.
Draw an oil sample to check the appearance of the flush lubricant. The sample should be clear. If
not, drain flush lubricant and refill. Run for two more days. When the sample is clear, proceed to the
next ste
p.
ADD NEW LUbRICANT
1.
Drain flush lubricant.
2. Install a new oil filter element. Refer to 6.7 Oil Filter procedures.
3. Change separator element. Refer to 6.8 Air/Oil Separator procedures.
4.
Add desired new lubricant. Check for leaks and top off the lubricant.
5.
If the oil sample looks clear, the new lubricant should be ok. If not, drain and recharge.
6.6 OIL SAMPLE FOR ANALYSIS
The first oil sample should be drawn after the compressor has run for 1,000 hours or 3 months. Intervals for
following oil samples will be determined by the analysis results.
FIGURE 6-1.
OIL ANALYSIS KIT
(
1
) (
2
) (
3
)
(P/N K00031-035)