2: Description
SN55, SN55S, SN55V, SN75, SN75S, SN75V User Manual
02250247-571 R04
23
Subject to EAR, ECCN EAR99 and related export control restrictions.
2.7
Air inlet system, functional
description
Refer to
Figure 2-6
. The compressor inlet system con-
sists of a dry-type air filter, a restriction gauge and an air
inlet valve.
The restriction gauge (located on the air filter) indicates
the condition of the air filter by showing red when filter
maintenance is required.
The poppet-type modulating air inlet valve directly con-
trols the amount of air intake to the compressor in
response to the operation of the pressure regulator.
Refer to
Full load mode—50 to 100 psig (3.4 to 6.9 bar)
on page 20. The inlet valve also acts as a check valve,
thus preventing reverse rotation when the compressor is
shut down.
WARNING
“The Plastic Pipe Institute recommends against
the use of thermoplastic pipe to transport com-
pressed air or other compressed gases in
exposed above ground locations, e.g. in exposed
plant piping.”
1
Sullube
®
should not be used with PVC piping sys-
tems. It may affect the bond at cemented joints.
Certain other plastic materials may also be
affected.
1
Plastic Pipe Institute, Recommendation B. Adopted
January 19, 1972.
Figure 2-6: Air inlet system
1. Air inlet filter
4. Separator/sump tank
2. Air inlet
5. Restriction indicator
3. Compressor unit