Suitmate Swimsuit Water Extractor 115V, Установка и обслуживание

Страница: 37 / 58

©2017 Extractor Corporation 115-V 20-Amp 60-Hz SUITMATE ® Unit
35
REMOVE AND REPLACE SHOCK BUMPER RINGS
' o t K i V ),567
Make certain you have all the correct parts and fasteners necessary for correct installation. Re-use any
components that are not damaged, otherwise replace them. Parts used in this process: (3) AEC1223 Shock
Bumper Rings, (3) AEC1228 Washers, (3) AEC1206 S.S. Pop Rivets. Plus any components required to
properly reinstall the Shock Mounts (Page 35), the Basket, Hub and Brake Disc Assembly (Page 27), the
Drive Unit Assembly (Page 23), and the Sub-Top and Top Assemblies (Page 17).
REMOVE SHOCK BUMPER RINGS
1) Remove SUITMATE
®
unit from the Wall Mount Bracket. See instructions beginning on Page 14.
2) Remove Top and Sub-Top Assemblies. See instructions beginning on Page 15.
3) Remove Drive Unit Assembly. See instructions beginning on Page 23.
4) Remove the (3) S.S. Hex Nuts that secure the (3) Shock Mounts to the (3) Shock Bumper Rings.
5) Remove the Shock Mount from the Shock Bumper Ring.
Note: Examine the positions of the 3 Shock % umper Rings. Two % umper Rings should be parallel to each
other. The third should be perpendicular to the other two. See % ottom 9 iew of Drive Unit on Page 3
for details.
6) Remove the rivet that holds the Shock Bumper Ring to the Motor Mounting Plate.
a. Punch out center of the rivet with a small drift punch.
b. Drill out the rivet.
c. Chisel off the rivet head. Make sure the rivet is completely removed.
Note: Set aside the small washer that helps to secure the Shock % umper Ring to the 0 otor 0 ounting
Plate. If the washers are deformed, they must be replaced.
REPLACE SHOCK BUMPER RINGS
1) Rivet the Shock Bumper Ring to the Motor Mounting Plate.
Note: % e certain to use the small washer (AEC 228) in riveting the Shock % umper Ring to the 0 otor
0 ounting Plate. 0 ake certain the Shock % umper Ring Assembly is properly aligned with the other two
% umper Rings. Failure to do so will prevent proper reassembly of the SUIT 0 ATE
®
unit.
2) Apply clear Silicone sealer (available locally) on the rivet head located on top of the Motor Mounting Plate.
3) Reinstall the (3) Shock Mounts. See instructions beginning on Page 35.
4) Reinstall Drive Unit Assembly. See instructions beginning on Page 23.
5) Reinstall Sub-Top and Top Assemblies. See instructions beginning on Page 17.
6) Reinstall the SUITMATE
®
unit to the Wall Mount Bracket. See instructions beginning on Page 14.
7) Retest the SUITMATE ® unit for proper operation, refer to TESTING AND OPERATION on Page 7.