©2017 Extractor Corporation
115-V 20-Amp 60-Hz SUITMATE
®
Unit
31
REMOVE / REPLACE BRAKE LEVER ASSEMBLY
'
o t
K
i
V
),567
Make certain you have all the correct parts and fasteners necessary for correct installation. Re-use any
components that are not damaged, otherwise replace them. Extractor recommends that a Brake Parts Kit
AEC2300 be purchased. In the absence of purchasing a Brake Parts Kit, the following parts are used in the
process: (2) AEC1614 Brake Hinge Pins, (4) AEC1603 White Plastic Bushings, (6) AEC1827 Nylon Washers,
(2) EC16 Brake Lever Assemblies, (2) AEC1601 Brake Support Brackets, (2) AEC1823 S.S. Pop Rivets. Plus
any components required to properly reinstall the Basket and Brake Disc Assembly (Page 29), the Drive Unit
Assembly (Page 23), and the Sub-Top and Top Assemblies (Page 17).
REMOVE BRAKE LEVER ASSEMBLY
1) Remove SUITMATE
®
unit from the Wall Mount Bracket. See instructions beginning on Page 14.
2) Remove Top and Sub-Top Assemblies. See instructions beginning on Page 15.
3) Remove Drive Unit Assembly. See instructions beginning on Page 23.
4) Remove Basket, Hub, and Brake Disc Assembly. See instructions beginning on Page 27.
Note:
0
ake certain that the C-clamps have been removed from the
%
rake
/
evers.
5) Remove the Long Compression Spring, Flat Washer, and White Plastic Bushing. Set them aside
for reassembly.
Note:
Pay attention to the location of the spring, washer and plastic bushing. It is recommended that the
compression spring be replaced with a new
/
ong Compression Spring (AEC
2).
6) Remove the rivet that holds the Brake Lever Assembly to the Brake Support Bracket on the Motor Mounting
Plate. Refer to drawing on bottom of Page 30.
a. Punch out the center of each rivet with a small drift punch.
b. Drill out the rivet.
c. Chisel off the rivet head.
7) Remove and discard the Brake Hinge Pin.
8) Remove the old Brake Lever Assembly.
Note:
Pay attention to the placement and alignment of the plastic bushings and plastic washers in the
%
rake
Assembly. Set them aside for reassembly. Inspect the
%
rake levers, springs, plastic bushings and
washers for wear and replace with new ones if necessary.
REPLACE BRAKE LEVER ASSEMBLY
1) Replace the Brake Lever Assembly by reversing the above procedure. A NEW Hinge Pin and pop rivet
MUST be used.
Note:
%
e certain that the plastic bushing and washers are in
³
new
´
condition and in their proper locations.
0
ake certain to reinstall the C-clamps on the
%
rake
/
evers. The height of the
%
rake Pad should be less than
3
8 inches (3.5cm) high as measured from the
0
otor
0
ounting Plate.
2) Reinstall the Brake Disc and Basket. See instructions beginning on Page 27.
3) Reinstall Drive Unit Assembly. See instructions beginning on Page 23.
4) Reinstall Sub-Top and Top Assemblies. See instructions beginning on Page 17.
5) Reinstall SUITMATE
®
unit to the Wall Mount Bracket. See instructions beginning on Page 14.
6) Retest the SUITMATE
®
unit for proper operation, refer to TESTING AND OPERATION on Page 7.
Содержание Swimsuit Water Extractor 115V
Страница 1: ...115V 60Hz Manual Installation Maintenance...
Страница 2: ......
Страница 57: ......
Страница 58: ...v052017...
