11
【
1
】
When determining the trigger position on site
(1) Put a mark on the Open area track with reference to the front
end of the door at the fully opened position.
(Use masking tape so that the track isn't marked.)
[Example]
Door pocket track with its length equal to the width of
door pocket.
(1)Drill holes for Pocket trigger according to drawing below.
(2) Fix Open area track, while following the right above figure,
since
the working sequence is different from regular process.
【
2
】
How to process the holes for Pocket trigger in advance
(2) Remove the open area track.
Remove the door according to the procedure -
How to remove the door, then remove the Open area track.
(3) Drill additional holes for trigger on the open area track.
(See the below drawing)
Front end of the door
Make sure that the
door is in the fully
opened position
(the trailing edge is
touching the
frame).
30
30
2x
I
5 additional holes
Mark as front end of the door
Door pocket track
Open area track
The pocket trigger mark
(from the factory)
Pocket trigger
(3)Mounting Open area track
Follow the figure to the bottom right, since the working sequence is
different from regular process.
(4) Hanging the door
Refer to the procedures
and following procedures on page 5.
2
Appendix 2
How to Shift the Connecting Position of The Tracks.
Appendix 1
Caution
2
Working sequence for mounting the open area track
(common to
【
1
】
and
【
2
】
)
2
1
Pull out the pocket
trigger slightly.
Fix it with screws.
3
24
Fix it with screws.
2x
I
5 additional holes
30
Margin
DN
Door width
Width of door pocket = Track length (door pocket)
Opening width = Track length (opened area)
Margin
DN
30
Position of leading edge of the door
Door pocket track
Open area track
Mark on Pocket trigger
(Factory-made)
Pocket trigger
Put a mark on the
open area track
with reference to
the leading edge of
the door.
Pull out the pocket
trigger and align it
with the drilled holes.
Leading edge of the door
at full opened position