6
When cutting, reinforce
the track to prevent deformation
at the cut section.
Caution
5
Installing Pocket Trigger
6
Verification Before Installing Soft Closer
Pocket trigger
Insert this end with the pin.
Pay attention to the direction.
Correct set position
Trigger catcher
Correct set position
I
6
Improper set position
OK
3
Installing Bracket
4
Installation of Door Guide Track
Bracket
⑧
Door guide track
Holder
Upper roller
①
Pan head tapping
screw4
×
45
Pay attention to setting the direction of the bracket. The
open part of the bracket should face in the outside direction.
7
Inserting Parts into Open Area Track.
Insert the parts in order from
to
.
You can insert the parts smoothly from the connecting end which has no burrs.
1
3
Leading edge
Connecting side
Upper
roller
3
Soft Closer
Pay attention to the direction.
2
Front trigger
1
The edge which has three countersunk
holes is the end to be connected.
Open area track
80
25
80
6
72
110
25
12
12
25
①
Door pocket track
2
1
Disassemble
Fastening
Outside
Outside
1 Cut the track to the same length as the door width.
2 Fasten the track with countersunk head tapping
screws 4x20 (not provided).
Countersunk head
tapping screws 4x20
(not provided)
Without verification the self closing feature may fail.
If the trigger position is wrong, pull back the
trigger catcher to the correct position using a
6 mm diameter round bar.
Caution
Slot for soft
closer/roller
Slot for trigger
Remove any dirt or aluminum chips
from the track.
Tape around rollers and upper track to
prevent inserted parts from falling.
Caution
(Red colored Part)
Insert the pocket trigger
until it reaches the end of
the track.