Subaru 2004 LEGACY, Руководство по обслуживанию

Страница: 576 / 609

PS-57
POWER ASSISTED SYSTEM (POWER STEERING)
Steering Gearbox [RHD Model]
15) Using the ST, install plug.
ST 34199AE090
PLUG WRENCH
Tightening torque:
64 N
⋅
m (6.5 kgf-m, 47.0 ft-lb)
16) Install the dust cover. Remove the vinyl tape.
17) Temporarily install the tie-rod to the rack, and
then operate it from lock to lock two or three times
to make it fit in. Remove the grease blocking air
vent hole.
CAUTION:
If operating the rack from lock to lock without
installing tie-rod, it may damage the oil seal. Al-
ways install the tie-rods LH and RH.
18) Apply a coat of grease to the sliding surface of
sleeve and seating surface of spring, and then in-
sert the sleeve into spring body.
Charge the adjusting screw with grease, and then
insert the spring into adjusting screw and install on
steering body.
19) Tighten the adjusting screw to specified torque.
Tightening torque:
9.8 N
⋅
m (1.0 kgf-m, 7.2 ft-lb)
20) After tightening the adjusting screw with the
specified tightening torque, loosen it.
Tightening torque:
4.9 N
⋅
m (0.50 kgf-m, 3.6 ft-lb)
21) After tightening the adjusting screw with the
specified tightening torque, loosen 37
°
it.
Tightening torque:
4.9 N
⋅
m (0.50 kgf-m, 3.6 ft-lb)
22) Remove the tie-rod.
23) Verify that play is within specified value. <Ref.
to PS-61, LIMIT, INSPECTION, Steering Gearbox
[RHD Model].>
24) Loosen the adjusting screw, and then apply liq-
uid gasket to at least 1/3 of the entire perimeter of
adjusting screw thread.
Liquid gasket:
THREE BOND 1141 (Part No. 004403006)
(1) Plug
(1) Dust cover
PS-00088
PS-00497
(1)
(1) Sleeve
(2) Spring
(3) Adjusting screw
(1) Apply liquid gasket to at least 1/3 of entire
perimeter.
PS-00167
(2)
(1)
(3)
PS-00092