Subaru 2004 LEGACY, Руководство по обслуживанию

Страница: 102 / 609

DI-32
DIFFERENTIALS
Rear Differential (T-type)
12) Tighten the self-locking nut.
Tightening torque:
70 N
⋅
m (7.1 kgf-m, 51 ft-lb)
13) Lower the transmission jack.
14) Install the propeller shaft. <Ref. to DS-11, IN-
STALLATION, Propeller Shaft.>
15) Install the heat shield cover.
16) Install the rear exhaust pipe and muffler.
17) After installing the rear differential carrier to the
vehicle, remove the filler plug, and refill the gear oil
to the bottom of plug hole.
Oil capacity:
0.8
2
(0.8 US qt, 0.7 Imp qt)
18) Tighten the filler plug.
NOTE:
Apply liquid gasket to the drain plug.
Liquid gasket:
THREE BOND 1105 (Part No. 004403010) or
equivalent
Tightening torque:
49.0 N
⋅
m (5.0 kgf-m, 36.2 ft-lb)
C: DISASSEMBLY
To detect the real cause of trouble, inspect the fol-
lowing items before disassembling.
• Tooth contact of hypoid driven gear and drive
pinion, and backlash
• Hypoid driven gear runout on its back surface
• Total preload of drive pinion
1) Set the ST on vise and install the differential as-
sembly to ST.
ST
398217700 ATTACHMENT
2) Drain the gear oil by removing plug.
3) Remove the air breather cap.
NOTE:
• Do not attempt to replace the air breather cap un-
less necessary.
• Replace the air breather cap with a new one
when removing it.
(A) Filler plug
(B) Drain plug
DI-00269
DI-00285
(A)
(B)
(A) Air breather cap
(B) Rear cover
ST
DI-00061
(A)
(B)
DI-00062