Subaru 2004 LEGACY, Руководство по обслуживанию

Страница: 567 / 609

PS-48
POWER ASSISTED SYSTEM (POWER STEERING)
Steering Gearbox [RHD Model]
5) Connect the return hose and pressure hose to
gearbox.
Tightening torque:
15 N
⋅
m (1.5 kgf-m, 10.8 ft-lb)
6) Install the universal joint. <Ref. to PS-21, IN-
STALLATION, Universal Joint.>
7) Connect the tie-rod end and knuckle arm, and
tighten with castle nut.
Castle nut tightening torque:
27 N
⋅
m (2.75 kgf-m, 19.9 ft-lb)
CAUTION:
When connecting, do not hit cap at the bottom
of tie-rod end with hammer.
8) After tightening the castle nut to specified tight-
ening torque, tighten it further within 60
°
until cotter
pin hole is aligned with slot in the nut. Fit the cotter
pin into nut, and then bend the pin to lock.
9) Install the front stabilizer. <Ref. to FS-16, IN-
STALLATION, Front Stabilizer.>
10) Install the front crossmember support plate and
jack-up plate.
11) Install the front exhaust pipe assembly. (Non-
turbo model) <Ref. to EX(H4SO 2.0)-8, INSTALLA-
TION, Front Exhaust Pipe.>
12) Install the under cover. <Ref. to EI-26, INSTAL-
LATION, Front Under Cover.>
13) Install the front wheels.
14) Tighten the wheel nuts to specified torque.
Tightening torque:
90 N
⋅
m (9.1 kgf-m, 65.8 ft-lb)
15) Lower the vehicle.
16) Remove the steering wheel. <Ref. to PS-20,
REMOVAL, Steering Wheel.>
17) Align the center of roll connector. <Ref. to AB-
23, ADJUSTMENT, Roll Connector.>
18) Install the steering wheel. <Ref. to PS-20, IN-
STALLATION, Steering Wheel.>
19) Connect the battery ground cable to battery.
20) Pour fluid into the oil tank, and bleed air. <Ref.
to PS-84, Power Steering Fluid.>
21) Check for fluid leaks.
22) Check the fluid level in oil tank.
23) After adjusting toe-in and steering angle, tight-
en the lock nut on tie-rod end.
Tightening torque:
85 N
⋅
m (8.7 kgf-m, 62.7 ft-lb)
(1) Return hose
(2) Pressure hose
PS-00536
(1)
(2)
(A) Cotter pin
(B) Castle nut
(C) Tie-rod end
DS-00042
(C)
(B)
(A)