Subaru 2004 LEGACY, Руководство по обслуживанию

Страница: 559 / 609

PS-40
POWER ASSISTED SYSTEM (POWER STEERING)
Steering Gearbox [LHD Model]
19) Insert the valve assembly into place while fac-
ing rack teeth toward pinion.
20) Tighten the bolts alternately to secure valve as-
sembly.
Tightening torque:
25 N
⋅
m (2.5 kgf-m, 18.1 ft-lb)
CAUTION:
Be sure to alternately tighten the bolts.
21) Apply a coat of grease to the sliding surface of
sleeve and seating surface of spring, and then in-
sert the sleeve into steering body.
Charge the adjusting screw with grease, and then
insert the spring into adjusting screw and install on
steering body.
22) Tighten the adjusting screw with specified
torque.
Tightening torque:
7.4 N
⋅
m (0.75 kgf-m, 5.4 ft-lb)
23) After tightening to the specified tightening
torque, loosen it by 25
°
.
24) Verify that play is within specified value. <Ref.
to PS-43, SERVICE LIMIT, INSPECTION, Steer-
ing Gearbox [LHD Model].>
25) Loosen the adjusting screw, and then apply liq-
uid gasket to at least 1/3 of the entire perimeter of
adjusting screw thread.
Liquid gasket:
THREE BOND 1141
26) Tighten the adjusting screw to specified torque.
Tightening torque:
7.4 N
⋅
m (0.75 kgf-m, 5.4 ft-lb)
27) After tightening to the specified tightening
torque, loosen it by 25
°
.
28) Install the lock nut. While holding the adjusting
screw with a wrench, tighten the lock nut using ST.
ST
926230000 SPANNER
Tightening torque (Lock nut):
39 N
⋅
m (4.0 kgf-m, 28.9 ft-lb)
NOTE:
Hold the adjusting screw with a wrench to prevent it
from turning while tightening lock nut.
29) Remove the gearbox from ST.
ST1
926200000 STAND
ST2 34199AG000 BOSS D
30) Install the four pipes on gearbox.
(1) Connect the pipe A and B to the gearbox.
Tightening torque:
13 N
⋅
m (1.3 kgf-m, 9.4 ft-lb)
(1) Sleeve
(2) Spring
(3) Adjusting screw
PS-00143
PS-00167
(2)
(1)
(3)
(1) Apply liquid gasket to at least 1/3 of entire
perimeter.
PS-00092