Sub-Zero Wolf 506UI, Руководство по обслуживанию

Страница: 31 / 52

Page 31
Component Access & Removal
Model 506 (UC Ice Maker)
Model 506 (UC Ice Maker)
4-6
#3752200 - Revision B - May, 2006
Bin Area Components
Bin Door
To remove the bin door:
1. Open the door and snap out the ice retainer by flex-
ing it and slipping it off the retaining studs.
(See
Figure 4-8)
2. Remove the screw closest to the door hinge on
either the right side or left side of door. (See Figure
4-9)
3. Remove soft white plastic filler plug covering door
hinge pin on side where the screw was removed.
4. Spread the trim piece free from the door.
5. Press down on inside of door liner next to hinge,
while pulling the door up and off of the hinge pin.
6. Close the door to a 30 degree open position, and
slide the door off of the hinge pin on the other side.
Friction Door Catch
The catch is located on the bottom of the escutcheon.
It can often be adjusted by adding washers under the
catch. If these does not correct the problem, the catch
should be replaced.
Cutter Grid
NOTE: See WARNING at beginning of this section.
The cutter grid is an arrangement of incoloy wires sup-
ported by a four sided frame in a manner to form
squares. There are two cutter grids available.
(See
Figure 4-10)
The cube cutter grid has wires that produce ice cubes
that are 1-1/4 inches by 1-1/4 inches. The wires are
arranged in a single circuit.
The cubelet cutter grid has wires that produce ice
cubelets that are 3/4 inch by 3/4 inch. The wires are
arranged in two parralel circuits.
ON OFF
CLEAN
Figure 4-8. Ice Retainer Removal
Figure 4-9. Bin Door Removal
Figure 4-10. Bin Door Removal
Ice Retainer
1-1/4” x 1-1/4” Cutter Grid
3/4” x 3/4” Cutter Grid
Screw